[ck] [patch v1] ck: xhci: Show Zhaoxin XHCI root hub speed correctly

Some Zhaoxin xHCI controllers follow usb3.1 spec, but only support gen1 speed 5G. While in Linux kernel, if xHCI suspport usb3.1,root hub speed will show on 10G. To fix this issue, read usb speed ID supported by xHCI to determine root hub speed. The patch is scheduled to be submitted to the kernel mainline in 2021. Signed-off-by: LeoLiu-oc &lt;LeoLiu-oc(a)zhaoxin.com&gt; --- drivers/usb/host/xhci.c | 20 +++++++++++++++++++- 1 file changed, 19 insertions(+), 1 deletion(-) diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c index 65cc362717fc..6b67b58ef304 100644 --- a/drivers/usb/host/xhci.c +++ b/drivers/usb/host/xhci.c @@ -5035,6 +5035,8 @@ int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks) */ struct device *dev = hcd->self.sysdev; unsigned int minor_rev; + struct pci_dev *pdev = to_pci_dev(dev); + u8 ssp_support = 1, i; int retval; /* Accept arbitrarily long scatter-gather lists */ @@ -5089,9 +5091,25 @@ int xhci_gen_setup(struct usb_hcd *hcd, xhci_get_quirks_t get_quirks) hcd->self.root_hub->speed = USB_SPEED_SUPER_PLUS; break; } + + /* usb3.1 has gen1 and gen2, Some zx's xHCI controller that follow usb3.1 spec + * but only support gen1 + */ + if (pdev->vendor == PCI_VENDOR_ID_ZHAOXIN) { + ssp_support = 0; + for (i = 0; i < xhci->usb3_rhub.psi_count; i++) { + if (XHCI_EXT_PORT_PSIV(xhci->usb3_rhub.psi[i]) >= 5) + ssp_support = 1; + } + if (ssp_support != 1) { + hcd->speed = HCD_USB3; + hcd->self.root_hub->speed = USB_SPEED_SUPER; + } + } + xhci_info(xhci, "Host supports USB 3.%x %sSuperSpeed\n", minor_rev, - minor_rev ? "Enhanced " : ""); + ssp_support ? "Enhanced " : ""); xhci->usb3_rhub.hcd = hcd; /* xHCI private pointer was set in xhci_pci_probe for the second -- 2.20.1